Specifications
Power requirements:
12 V DC
(10.8 V to 13.2 V)
42 V to 57 V DC
(PoE++ power supply)
Current consumption:
5.0 A (XLR connector input)
1.5 A (PoE++ power supply)
indicates safety information.
GENERAL
Ambient operating temperature:
0 °C to 40 °C (32 °F to 104 °F)
Storage temperature:
–20 °C to 50 °C (–4 °F to 122 °F)
Ambient operating humidity:
20% to 90% (no condensation)
Mass: Approx. 4.6 kg (10.12 lb) (excluding mount bracket)
Dimensions (W × H × D):
213.0 mm×277.0 mm×240.0 mm
(8-3/8 inches × 10-29/32 inches × 9-7/16 inches)
(excluding protrusions, mount bracket)
Finish: AW-UE160WP/AW-UE160WPC/AW-UE160WE/
AW-UE160WED: Pearl white
AW-UE160KP/AW-UE160KPC/AW-UE160KE/
AW-UE160KED: Black
Controller supported:
AW-RP150, AW-RP60, AK-HRP1010, AK-HRP1015,
AK-HRP250
INPUT
Input connector
DC IN 12 V
G/L IN: BBS (Black Burst Sync), tri-level sync supported
AUDIO INPUT1/2: Supports microphone or line input (SDI/HDMI/IP)
AAC compatible (compatible with IP only)
XLR×2, 3-pin, female
Balanced input 2ch
• Microphone gain during microphone input:
60 dB or 40 dB
Supports phantom power,
Plug-in power compatible, supply voltage:
47 V ±2 V
Input impedance: Approx. 10 kΩ
• During LINE input
Input level: 0 dBu or +4 dBu
Input impedance: Approx. 10 kΩ
• Input volume variable range:
–40 dB to 0 dB to +20 dB (1 dB step)
• Embedded audio output level:
–12 dBFS/–18 dBFS/–20 dBFS
• Sampling frequency:
48 kHz
• Quantization bit rate:
24bit (SDI, HDMI), 16bit (IP)
OUTPUT
Video output
HDMI: HDMI 2.0 connector
4:2:2/10bit
• HDCP is not supported.
• Viera Link is not supported.
12G SDI OUT: SMPTE2082-1 / SMPTE424M / SMPTE292M /
75 Ω (BNC×1)
• Level-A/Level-B supported
3G SDI OUT1: SMPTE424M / SMPTE292M /75 Ω (BNC×1)
• Level-A/Level-B supported
3G SDI OUT2/PM: SMPTE424M / SMPTE292M /75 Ω (BNC×1)
• Level-A/Level-B supported
SFP+: Conforms with SFP+ (Single Fiber)
• Does not support optical signal input
USB: USB3.0 HOST 5G mobile router (supports USB
tethering)
INPUT/OUTPUT
Input/Output connector
LAN: RJ-45
LAN terminal for IP control and video transmission
PoE++ power terminal (IEEE802.3bt compliant)
RS‑422: CONTROL IN RS-422A (RJ-45)
SFP+(SMPTE ST2110):
Supported standards:
• SMPTE ST2110-10/-20/-21/-30
• PTP SMPTE ST2059-2
• NMOS IS-04/IS-05
Number of outputs:
Video×3 (main line, Crop, Monitor), audio×2
Number of inputs: Video×1 (RETURN)
Video formats: FHD
• Conforms with system format
FUNCTIONS AND PERFORMANCE
[Camera unit]
Imaging sensors: 1.0-type 4K MOS×1
Lens: Motorized Optical 20× zoom, F2.8 to F4.5
[f=8.8 mm (11/32 inches) to 176 mm
(6-15/16 inches); 35 mm (1-3/8 inches)
equivalent: 24.5 mm (31/32 inches) to 490.0 mm
(19-9/32 inches)]
i.Zoom (UHD: 24×, FHD: 32×)
• 20× optical zoom, iZoom and Digital Zoom
switching
D.Extender (1.4×, 2×)
Angle of view range:
Horizontal angle of view: 75.1° (wide) to 4.0° (tele)
Vertical angle of view: 46.7° (wide) to 2.3° (tele)
Diagonal angle of view: 82.8° (wide) to 4.6° (tele)
Optical filter: Through, 1/4, 1/16, 1/64, IR through
• Equipped with Low pass filter
(IR through is used as “Night mode”)
205
To Next Page
Loading...
