MONITOR DISPLAY
WFM
MODE [OFF, ON(Y), ON(Y/Pb/Pr)]
Switch the WaveForm display setting.
OFF WaveForm not displayed.
ON(Y) Waveform of Y component only displayed.
ON(Y/Pb/Pr) Waveform of Y, Pb, and Pr components each displayed.
POSITION [UR, BR, BL, UL]
Select the area for displaying the WaveForm.
UR Display WaveForm in the top right area.
BR Display WaveForm in the bottom right area.
BL Display WaveForm in the bottom left area.
UL Display WaveForm in the top left area.
(Example)
WaveForm display when [MODE] is [ON(Y/Pb/Pr)] and [BR] is
selected for [POSITION] (The displayed image is for reference.)
<NOTE>
• The WaveForm is displayed only on devices connected to the
3G SDI OUT2/PM connector, and is not displayed on devices
connected to the connectors of other output systems.
STATUS INDICATOR
For items that have been set to [ON], when the designated status is
reached and where [CHAR] is [ON], the statuses are displayed in the
images of connectors where [OUTPUT ITEM] is set to [STATUS].
RETURN SELECT [OFF, ON]
When [ON], the character string set in [RETURN] – [RETURN1 ID] is
displayed as OSD in the region at the top center of the screen.
The RETURN SELECT character string is displayed only on devices
connected to the 3G SDI OUT2/PM connector.
(Example)
L↑ ＋３．２／ー３．２ ↓R
F↓ ー０．８／＋０．８ ↑B
RETID
RETURN SELECT (displayed constantly)
STATUS(AUTO) [OFF, ON]
When [ON], the following status indications are displayed on the OSD:
- Display of the results after auto white balance is run
- Display of the results after auto black balance is run
- Error display when an error occurs
(Example)
L↑ ＋３．２／ー３．２ ↓R
F↓ ー０．８／＋０．８ ↑B
RETID
AWB
OK
STATUS(AUTO)
(Displayed for 5 seconds only under certain conditions)
LEVEL GAUGE [OFF, ON]
When [ON], the status of the incline (horizontally, to the left or right or
front and back) of the unit installation is displayed as OSD in the top
left of the screen.
(Example)
L↑ ＋３．２／ー３．２ ↓R
F↓ ー０．８／＋０．８ ↑B
RETID
LEVEL GAUGE (displayed constantly)
In the case of the display above, the unit is installed at an inclination
of 3.2° upward to the left and 1.8° upward in to the front.
The maximum incline is ±9.9°, and when there is an incline of 10° or
greater, the display shows “±9.9”.
<NOTE>
• LEVEL GAUGE is displayed only through SDI, HDMI, and SMPTE
ST2110. It is not displayed with High bandwidth NDI and IP
transmission (H.264/H.265/M-JPEG).
• The LEVEL GAUGE value is not updated during PAN/TILT
operation.
70
Camera menu items (continued)
To Next Page
Loading...
