The genlock adjustment is performed to achieve phase alignment by
applying external synchronization (genlock) when a multiple number of
cameras will be used or when the unit will be used in combination with
other devices.
This unit supports BBS (Black Burst Sync) and tri-level sync external
synchronization signals.
By setting [BASIC CONFIG] – [SYNC SIGNAL] – [REF SIGNAL] to
[BBS/TRI-LEVEL SYNC], it is possible to synchronize with the external
synchronization signal output from the G/L connector.
Ask your dealer to perform this adjustment.
(Use a dual-trace oscilloscope for the adjustment.)
Horizontal phase adjustment
Observe the waveforms of the external sync signal input (tri-level sync
signal) and video signal output on the dual-trace oscilloscope, and use
the wireless remote control or controller to bring the horizontal phase
into alignment.
External sync signal
input
(tri‑level sync signal)
Video signal output
Bring the horizontal
phase into alignment.
Example: When the tri‑level sync phase is adjusted
It is possible to adjust the horizontal phase by changing
the values in [BASIC CONFIG] – [SYNC SIGNAL] – [GEN-
LOCK] – [H PHASE-COARSE] and [H PHASE-FINE].
Genlock adjustment
47
To Next Page
Loading...
