Panasonic HEVC Advance AW-UE160WP - Page 126

z JPEG
Set JPEG image settings.
The setting is confirmed with the [Set] button.
There are a total of 3 channels available for JPEG image setting.
<NOTE>
• [JPEG(2)] and [JPEG(3)] cannot be set when the [Streaming mode] is
[JPEG(UHD)], [NDI|HX V2] or [High bandwidth NDI].
JPEG transmission [On, Off]
Set whether to transmit JPEG images.
Factory settings: On
Image capture size [3840×2160, 1920×1080, 1280×720,
640×360, 320×180]
When displaying JPEG images, select the resolution for image display
from the following.
JPEG(1) 3840×2160, 1920×1080, 1280×720, 640×360, 320×180
JPEG(2) 640×360, 320×180
JPEG(3) 640×360, 320×180
Factory settings:
JPEG(1): 1280×720
JPEG(2): 640×360
JPEG(3): 320×180
<NOTE>
• [3840 x 2160] can be selected when the [Streaming mode] is
[JPEG(UHD)].
z Initial display setting
Set initial display settings for the Live screen [Live].
The setting is confirmed with the [Set] button.
Stream [H.264(1), H.264(2), H.264(3), JPEG(1), JPEG(2),
JPEG(3)]
Select the type of images to display in the Live screen [Live].
H.264(1) Display videos (H.264(1)).
H.264(2)
Display videos (H.264(2)).
H.264(3)
Display videos (H.264(3)).
JPEG(1) Display still images (JPEG(1)).
JPEG(2) Display still images (JPEG(2)).
JPEG(3) Display still images (JPEG(3)).
Factory settings: H.264(1)
<NOTE>
• This setting may switch automatically according to the [Streaming
mode].
z Timecode Overlay
Timecode Overlay [Enable, Disable]
Set whether timecode information is overlayed on IP transmission
data.
Factory settings: Disable
<NOTE>
• This function can be set only when NTP is enabled.
• This function overlays the time information synchronized with NTP.
126
Web screen configurations (continued)