Streaming format
Make settings for H.264 images used for MPEG2-TS over UDP
transmission.
The setting is confirmed with the [Set] button.
Refer to the explanation of [H.264] (→ page 127) for information
about [Profile type], [Image capture size], [CBR/VBR], [Frame rate],
and [Max bit rate(per client)].
<NOTE>
• [Streaming format] settings cannot be changed during MPEG2-TS
over UDP transmissions.
• When [IP(UDP)] of [Tracking Data Output] is set to [On], video
transmission via IP may be delayed or the video may suffer frame
loss. (→ page 165)
We recommend [IP(UDP)] of [Tracking Data Output] is set to [Off]
during MPEG2-TS over UDP transmission.
z NDI|HX V2/NDI|HX V2(UHD)
Make NDI|HX V2 transmission settings.
The setting is confirmed with the [Set] button.
NDI|HX V2
<NOTE>
• This unit restarts when [Streaming mode] is changed to [NDI|HX
V2], or when changed from [NDI|HX V2] to another mode.
Source name
Sets the device name displayed when this unit is detected by software
applications and hardware compatible with NDI|HX.
Factory settings: NDI_Device-[serial number of this unit]
Maximum number of
characters
1 to 32 characters
Characters that can be
entered
Alphanumeric characters, symbols:
- _
Protocol [TCP, UDP, RUDP]
Sets the format of unicast transmission to be used.
Factory settings: RUDP
Multicast Transmit [On, Off]
Sets whether to perform multicast transmissions of images for
software applications and hardware that are compatible with NDI.
Factory settings: Off
Address(IPv4) [IPv4 : 224.0.0.0 to 239.255.255.255]
Enter the multicast IP address.
Images and audio are transmitted to the specified multicast address.
Factory settings: 239.192.0.30
<NOTE>
• Check the multicast IP addresses available for use before
entering.
133
Web screen configurations (continued)
To Next Page
Loading...
