DETAIL
z DETAIL SETTING
<NOTE>
• For all of the DETAIL SETTING items, setting is not possible when
[V-LOG] is [On] and [V-LOG PAINT SW] is [Off].
DETAIL [Off, On]
Set On/Off for image contour (image sharpness) adjustments.
Factory settings: On
MASTER DETAIL [–31 to +31]
Adjust the contour correction level (master).
This is only enabled when [DETAIL] is set to [On].
Factory settings: 0
PEAK FREQUENCY [1 to 8]
Set the boost frequency of detail.
This is only enabled when [DETAIL] is set to [On].
Factory settings: 6
CRISP [00 to 63]
Set the level of noise reduction for the detail signal.
This is only enabled when [DETAIL] is set to [On].
Factory settings: 0
GAIN(+) [–31 to +31]
Set the level of the detail signal in the plus direction (brighter
direction).
This is only enabled when [DETAIL] is set to [On].
Factory settings: 0
GAIN(–) [–31 to +31]
Set the level of the detail signal in the minus direction (darker
direction).
This is only enabled when [DETAIL] is set to [On].
Factory settings: 0
153
Web screen configurations (continued)
To Next Page
Loading...
