z SKIN TONE DETAIL SETTING
<NOTE>
• For all of the SKIN TONE DETAIL SETTING items, setting is not
possible when [V-LOG] is [On] and [V-LOG PAINT SW] is [Off].
SKIN TONE DETAIL [Off, On]
This function smooths skin and produces a more beautiful image.
Set On/Off for the skin tone detail function.
Factory settings: Off
MEMORY SELECT [A, B, C]
Select the skin tone table of the subject for the skin tone effect.
Factory settings: A
ZEBRA [Off, On]
Set On/Off for the zebra display of the skin tone area.
The zebra pattern is displayed only on devices connected to the
3G SDI OUT2/PM connector.
Factory settings: Off
<NOTE>
• This cannot be set when [ZEBRA] in [DOWNCON SETTING] is
[On].
ZEBRA EFFECT MEMORY
[A, B, C, A+B, A+C, B+C, A+B+C]
Select the skin tone table for the zebra display.
Factory settings: A+B+C
SKIN TONE EFFECT MEMORY
[A, B, C, A+B, A+C, B+C, A+B+C]
Select the skin tone table for the skin tone effect.
Factory settings: A+B+C
SKIN TONE CRISP [–63 to 0 to +63]
Adjust the skin tone detail.
Factory settings: 63
I CENTER [000 to 255]
Set the central position above the I axis (area where skin tone is to
take effect).
Factory settings: 65
I WIDTH [000 to 255]
Set the width of the area where the skin tone is to take effect above
the I axis, centered on [I CENTER].
Factory settings: 63
Q WIDTH [000 to 255]
Set the width of the area where the skin tone is to take effect above
the Q axis, centered on [I CENTER].
Factory settings: 32
Q PHASE [0 to 359]
Set the phase of the area where skin tone is to take effect based on
the Q axis.
Factory settings: 90
Monitor display setting display [Monitor
Display]
WFM
Mode [Off, On(Y), On(Y/Pb/Pr)]
Switch between displaying and hiding the WaveForm.
Off WaveForm not displayed.
On(Y) Waveform of Y component only displayed.
On(Y/Pb/Pr) Waveform of Y, Pb, and Pr components each displayed.
Factory settings: Off
Position [UR, BR, BL, UL]
Select the area for displaying the WaveForm.
UR Display WaveForm in the top right area.
BR Display WaveForm in the bottom right area.
BL Display WaveForm in the bottom left area.
UL Display WaveForm in the top left area.
Factory settings: UR
<NOTE>
• The WaveForm is displayed only on devices connected to the
3G SDI OUT2/PM connector, and is not displayed on devices
connected to the connectors of other output systems.
Status Indicator
For items that have been set to [On], when the designated status is
reached and where [CHAR] is [ON], the statuses are displayed in the
images of connectors where [OUTPUT ITEM] is set to [STATUS].
RETURN SELECT [Off, On]
When [On], the character string set in [RETURN] – [RETURN1 ID] is
displayed as OSD in the region at the top center of the screen.
The RETURN SELECT character string is displayed only on devices
connected to the 3G SDI OUT2/PM connector.
STATUS(AUTO) [Off, On]
When [On], the following status indications are displayed on the OSD:
- Display of the results after auto white balance is run
- Display of the results after auto black balance is run
- Error display when an error occurs
Factory settings: Off
156
Web screen configurations (continued)
To Next Page
Loading...
