z mDNS
By setting an [mDNS] [Host name], it is possible to access this unit via
http://Host name.local.
Maximum number of
characters
63 characters
Characters that can
be entered
Alphanumeric characters, symbols : -
Factory settings: panasonic-ptz
<NOTE>
• Proper operation cannot be guaranteed if there is another camera with
the same settings in the same network.
z 802.1X
Makes settings for the IEEE 802.1X client.
The setting is confirmed with the [Set] button.
<NOTE>
• You will require 802.1X knowledge in order to complete the settings.
Consult the network administrator for details.
• It is necessary to make settings for an authentication server and
Authenticator separately when building a system that uses this
function.
Consult the network administrator for details.
• In a system configuration where 802.1X is enabled, it is not possible to
control the camera from AW-RP150 or AW-RP60.
• Before setting, go to either the [Date&Time] settings screen or the
[NTP] settings screen to set the time for this unit.
Proper operation may not be possible if the time has not be set
correctly for the unit.
• Before setting, in the [Date&Time] settings screen, set [Memory] to
[Enable].
802.1X [On, Off]
Sets whether to use the 802.1X function.
Factory settings: Off
EAP authentication method [TLS, PEAP]
Makes settings for the authentication method used for the 802.1X
function.
This unit supports authentication methods using TLS or PEAP.
Factory settings: TLS
<NOTE>
• Proper operation may not be possible if it does not match the
authentication method permitted by the authentication server.
TLS
Makes settings for when the TLS authentication method is used.
177
Web screen configurations (continued)
To Next Page
Loading...
