Maintenance screen [Maintenance]
Initialize the setting data of the unit, reboot the unit, etc.
Fan1 [Auto, Low, Mid, High]
Set the behavior of cooling fan 1 (on the LENS unit side).
Fan2 [Auto, Low, Mid, High]
Set the behavior of cooling fan 2 (on the base unit side).
Auto Enable automatic control of the cooling fan.
Low Operate the cooling fan at low speed.
Mid Operate the cooling fan at medium speed.
High Operate the cooling fan at high speed.
<NOTE>
• Even if this is set to [Low], [Mid], or [High], the cooling fan may be
forcibly stopped when the temperature is low.
• Even if this is set to [Low] or [Mid], the cooling fan may be forcibly
operated at [High] when the temperature is high.
Wireless Control [Enable, Disable]
[Enable] or [Disable] is set here for operations conducted from the
wireless remote control.
Wireless ID [CAM1, CAM2, CAM3, CAM4]
Set the remote control ID (CAM1 to CAM4).
The [CAM1] to [CAM4] in this setting correspond to the CAMERA <1>
to <4> buttons on the wireless remote control.
<NOTE>
• When the power is turned on from Standby with the wireless remote
control, operations from the wireless remote control are possible
irrespective of this setting value.
• This item is not reflected immediately when the setting is changed.
It is reflected when the unit is set to Standby mode, and then the
power is turned ON with any external device other than the wireless
remote control.
• This setting is not reflected when the power is turned ON with this
item set to [Disable]. It is reflected when the unit is set to Standby
mode, and then the power is turned ON with any external device
other than the wireless remote control.
Status Lamp [Enable, Disable]
[Disable] or [Enable] is set here for the status display lamp. When you
want the status display lamp to stay off while this unit is in operation,
set to [Disable].
<NOTE>
• Even when set to [Disable], the status display lamp may light
up when this unit is starting up, updating firmware, or trouble is
occurring.
Reset to the default (Except the network settings)
When the [Execute] button is clicked, the unit’s settings are returned
to their defaults.
When the initialization operation is started, the unit is restarted so no
operations can be undertaken for about 2 minutes.
<NOTE>
• The following setting items will not be returned to defaults.
- [Live page - Automatic installation of viewer software]
- [Live page - Smoother live video display on the browser(buffering)]
- All settings under [User mng.]
- All settings under [Network - Network]
- [HTTPS - Connection]
- [HTTPS - HTTPS port]
- [HTTPS - HTTPS mode]
- HTTPS: CRT key, server certificate
- All settings under [UPnP]
• [AWB] and [ABB] adjustment values will not be returned to defaults.
• The settings for [Format] and [Frequency] (→ page 112) are not
initialized.
Reboot
When the [Execute] button is clicked, the unit is rebooted.
After the unit has been rebooted, no operations can be undertaken for
about 2 minutes as is the case when the unit’s power is turned on.
187
Web screen configurations (continued)
To Next Page
Loading...
