Panasonic KV-S2065L - Page 134

No. Item Setting Contents Default
1 Version
_
2 Buzzer OFF ON ON
3 SCSI ID
No. 0 - 7
6
4 Terminator Enable Disable Enable
6-a
Clean Roller
Warning (Disp. %)
~% 0%
6-b
Clean Roller (Clear
warning for "Clear
Roller")
Clear
-
0%
-
KV-S2065
7-a
Replace Roller
(Disp. %)
~%
7-b Clear
8 Product ID
KV-
S2065
KV-
SS855
KV-
S2055
KV-
S6055
KV-
S6045
9 Sleep Mode
(Set period to enter
in Sleep Mode)
Disable
After 1min
~ 60min
15min
Factory
Setting
KV-S2065
_
_
_
ON
6
Enable
0%
0%
15min
Replace Roller
(Clear warning for
"Replace Roller")
Note:
If the scanner is the last device in the SCSI chain, then the terminator should be set to "Enable".
But, under the above SCSI chain and scanner's turn-off, the terminator should be attached to
the SCSI connector on the scanner.
Setting the SCSI ID will be activated after turning the power OFF and turning it ON again.
Setting the terminator will be activated after turning the power OFF and turning it ON again.
5
Transfer Rate
20
MByte/sec
20
MByte/sec
20
MByte/sec
10
MByte/sec