10 TROUBLESHOOTING
TOP PREVIOUS NEXT
Error Codes are listed in section 9.7 Error Code.
Test the check points in order from the first entry.
Error Code Possible Cause Check Point
F10 Program ROM Error on MAIN CONTROL Board • Replace the Program ROM
• Replace the MAIN CONTROL Board
F11 Work RAM Error on MAIN CONTROL Board • Replace the MAIN CONTROL Board
F17
On Board RAM Error
• Replace the SCSI Board
• Replace the MAIN CONTROL Board
• Replace the MOTHER Board
F18
DIMM Error
• Replace the DIMM
• Replace the SCSI Board
• Replace the MOTHER Board
• Replace the MAIN CONTROL Board
F20 Shading RAM Error • Replace the MAIN CONTROL Board
F21 Line RAM Error • Replace the MAIN CONTROL Board
F26 Patch RAM Error • Replace the MAIN CONTROL Board
F29 Front Gamma RAM Error • Replace the MAIN CONTROL Board
F30 Back Gamma RAM Error • Replace the MAIN CONTROL Board
F31 Dither RAM Error • Replace the MAIN CONTROL Board
F34 EEPROM Error • Replace the MAIN CONTROL Board
F36 GA Sensor Error • Replace the MAIN CONTROL Board
F37 GA Image Error • Replace the MAIN CONTROL or SCSI Board
F40 Hopper Drive Error • Check the Hopper Position Cable
• Check the RELAY ( LOWER ) Board Cable
• Check the Gears in the Hopper Drive
• Replace the HOPPER POSITION Board
• Replacethe RELAY ( LOWER ) Board
• Replace the MOTHER Board
• Replace the MAIN CONTROL Board
• Replace the DRIVE Board
F50 Waiting Sensor Error • Remove any dust on the LED on the WAITING LED Board, or on the light
receptor on the WAITING SENSOR Board
• Check that the LED on the WAITING LED Board, the light receptor on the
WAITINGSENSOR Board and the slot location on the carrier board are properly
aligned
• Check the WAITING LED Board Cable
• Check the RELAY ( LOWER ) Board Cable
• Check the Waiting Sensor Cable
• Checkthe RELAY ( UPPER ) Board Cable
• Replace the WAITING LED Board
• Replace the WAITING SENSOR Board
• Replace the RELAY ( LOWER ) Board
• Replace the RELAY ( UPPER ) Board
• Replacethe MOTHER Board
• Replace the MAIN CONTROL Board
• Check the Starting Position Sensor Cable
• Replace the STARTING POSITION SENSOR Board
To Next Page
Loading...
