Panasonic KV-S2065L - Feed Motor

file://///serwer/instr/CD/900-999/CD945/KV-S2065L_ALL_SVC/Viewing/SGML_VIEW_DATA/ALL/KV-S2065L/SVC/s0803110000.html
8.3.11 Feed Motor
TOP PREVIOUS NEXT
1. Remove Drive Roller-1. (See 8.3.4-(1), (2), (3))
2. Remove the screw (A) from the Retard Transmission Shaft Holder.
Note:
When reattach a rink spacer to the scanner, be careful with the direction of the spacer.
1. Remove 3 screws (B).
2. Remove the Feed Motor with the Attachment Plate screws.
3. Disconnect the connector from the DRIVE Board to this motor.
TOP PREVIOUS NEXT
file://///serwer/instr/CD/900-999/CD945/KV-S2065L_A...g/SGML_VIEW_DATA/ALL/KV-S2065L/SVC/s0803110000.html [2010-08-24 21:10:50]