4.5 Installing DIMM Module
TOP PREVIOUS NEXT
Insert the DIMM module into the
connector on the SCSI interface board at
an angle [ Place ( 1 ) ]. Push in the
module as far as it goes. The levers
should lock automatically. If not, push
the levers tolock the module in [Place (
2 ) ].
Note:
● Be sure that the DIMM
module will be in the proper
position and the proper side.
● To remove the DIMM
module, release the white
levers at both sides of the
connector.
TOP PREVIOUS NEXT
To Next Page
Loading...
