Panasonic KV-S2065L - Page 23

file://///serwer/instr/CD/900-999/CD945/KV-S2065L_ALL_SVC/Viewing/SGML_VIEW_DATA/ALL/KV-S2065L/SVC/s0409020000.html
To active the SCSI ID settings, press the HOME Key to return to READY, then turn the unit
off and on.
1. Press the SELECT [
] Key or [
] Key to select the desired setting.
The [
] Key moves to the next content as shown below.
The [
] Key moves to the previous content.
Note:
❍ If the scanner is the last device in the SCSI chain, then the terminator should be set to
Enable. But, under the above SCSI chain and scanners turn-off, the terminator should
be attached to the SCSI connectoron the scanner.
❍ Setting the SCSI ID will be activated after turning the power OFF and turning it ON
again.
❍ Setting the terminator will be activated after turning the power OFF and turning it ON
again.
TOP PREVIOUS NEXT
file://///serwer/instr/CD/900-999/CD945/KV-S2065L_AL...ng/SGML_VIEW_DATA/ALL/KV-S2065L/SVC/s0409020000.html (2 z 2) [2010-08-24 21:09:02]