Panasonic KX-TD816E - Page 463

8-6 Quick Reference
8 Quick Reference
❐ Handset / Headset Selection
•Enter the programming mode.
•Dial 9.
•Dial 1 or 2.
- 1 : Handset mode
- 2 : Headset mode
•Press STORE button.
•Exit the programming mode.
❐ Intercom Alerting Assignment
•Enter the programming mode.
•Dial 4.
•Dial 1 or 2.
- 1 : Ring-Calling (Tone Call) mode
- 2 : Voice-Calling mode
•Press STORE button.
•Exit the programming mode.
❐ Live Call Screening Mode Set†
•Enter the programming mode.
•Dial 1.
•Dial 1 or 2.
- 1 : Hands-free mode
- 2 : Private mode
•Press STORE button.
•Exit the programming mode.
❐ Phantom Extension Bell On / Off
Set
•Enter the programming mode.
•Press the Phantom Extension button.
•Press the same Phantom Extension button
again.
•Dial 1 or 2.
- 1 : Ring off
- 2 : Ring on
•Press the STORE button.
•Exit the programming mode.
❐ Preferred Line Assignment
— Incoming
•Enter the programming mode.
•Dial 2.
•Dial 1, 2, or 3 + CO line number.
- 1 : No Line Preference
- 2 : Ringing Line Preference
- 3 + CO line number
: Prime Line (CO Line) Preference
•Press STORE button.
•Exit the programming mode.
❐ Preferred Line Assignment
— Outgoing
•Enter the programming mode.
•Dial 1.
•Dial 1, 2, 3 + CO line number, or press
INTERCOM button.
- 1 : No Line Preference
- 2 : Idle Line Preference
- 3 + CO line number
: Prime Line (CO Line) Preference
- INTERCOM
: Prime Line (INTERCOM) Preference
•Press STORE button.
•Exit the programming mode.
❐ Ringing Tone Selection for CO
Buttons
•Enter the programming mode.
•Press the desired CO button.
•Press the same CO button again.
•Dial the tone type number (1 through 8).
•Press STORE button.
•Exit the programming mode.