Panasonic KX-TDA600

4. To protect the back board from static electricity, do not touch parts on the back board in the main unit and
PSU. To discharge static electricity, touch ground or wear an earthing strap.
The following
procedures are for installing or replacing a PSU only. Do not replace or remove the PSU
for any other purpose.
Installing the Power Supply Unit
1. Insert the PSU along the guide rails.
CAUTION
For safety reasons, do not touch parts in the PSU.
Guide Rail
2. Push the release lever in the direction of the arrow, so that the PSU engages securely with the connector
on the back board.
Release Lever
Back Board
Installation Manual 103
2.2.9 Installing/Replacing the Power Supply Unit