Panasonic KX-TDA600

2.11.5 Site Survey
The PS has a Radio Signal Test mode that monitors the state of the radio link to the CS. After installing the
CSs temporarily, set the PS to Radio Signal Test mode and measure each CS coverage area. Then, record
the results on the map of the installation site.
Testing the Radio Signal Strength
Note
Display prompts for the site survey are only available in English.
1. Enter Radio Signal Test mode.
Using the KX-TD7684/KX-TD7694
<< SEARCHING >>
CS NO.1 LEVEL:12
*1
SAVE:0123456789
*2
1
9
9
0
Press 1, 9, and POWER
for more than 2 seconds.
1 to 9
CS No.
Scan Data No.
0 to 9
Display example:
To store the scan data
Using the KX-TD7680
Display example:
Press 1, 9, and POWER
for more than 2 seconds.
<< SEARCHING >>
CS NO.1 LEVEL:12
*1
SAVE:0123456789
*2
1 to 9
CS No.
1
9
9
0 to 9
Scan Data No.
To store the scan data
0
Using the KX-TD7690
Display example:
Press 1, 9, and POWER
for more than 2 seconds.
<< SEARCHING >>
CS NO.1 LEVEL:12
*1
SAVE:0123456789
*2
1 to 9
CS No.
1
9
9
0 to 9
Scan Data No.
To store the scan data
0
Note
*1: CS number and radio signal strength level.
*2: Scan data
(test result) number. Empty memory space will be indicated by a number; stored memory
space will be indicated by a "-".
246 Installation Manual
2.11.5 Site Survey