Panasonic KX-TDA600

2.2.8 Wall Mounting (KX-TDA600/KX-TDA620)
Mounting Shelves
WARNING
• Make sure that
the wall that the shelf will be attached to is strong enough to support the shelf.
If not, it is necessary for the wall to be reinforced.
• Only use the wall-mounting equipment (anchor plugs, screws, metal bracket) included with the
PBX.
CAUTION
• When placing the metal bracket, make sure that the
"TOP" arrow is pointing upward.
• Do
not
block the openings of the shelf. Allow space of at least 20 cm above and 10 cm at the sides of
the shelf.
• Make sure that the surface behind the shelf is flat and free of obstacles, so that the openings on the
back of the shelf will not be blocked.
• Make sure that the surface behind the shelf is not made of wood.
Notice
• When driving the
screws into the wall, be careful to avoid touching any metal laths, wire laths or metal
plates in the wall.
• When this product is no longer in use, make sure to detach it from the wall.
• Be careful not to drop the shelf.
Note
• Make sure to remove the front cover from each shelf before installing the shelves (refer
to "2.2.3 Opening/Closing the Front Cover").
• Do not install any optional service cards or a PSU in the shelves before installation.
• For details about the dimensions and weight of the PBX, refer to "1.4.1 General Description".
Installation Manual 99
2.2.8 Wall Mounting (KX-TDA600/KX-TDA620)