Panasonic KX-TDA600

2.2.7 Installation of 4-shelf System (Side-by-side Type)
When vertical space is limited, it is possible to install shelves side-by-side. Installing the system using base
stands (supplied with an optional Mounting Kit) makes it easy to reinstall shelves in a different place.
Construction of 4-shelf System (Side-by-side Type)
Expansion Shelf 3
Expansion Shelf 2
Metal Bracket
Metal Bracket
Support Bracket
Base Stand
Expansion Shelf 1
Wall Bracket
(Right)
Wall Bracket
(Left)
Basic Shelf
Metal Bracket
Metal Bracket
Base Stand
Support Bracket
Note
• Make sure to remove the front cover from each shelf before installing the shelves (refer
to "2.2.3 Opening/Closing the Front Cover").
• Do not install any optional service cards or a PSU in the shelves before installation.
• Make sure to install the shelves where the Bus Cable (supplied with a BUS-M card or BUS-ME card)
can reach the shelves.
• Do not block the openings of the shelf. Allow space of at least 10 cm at the sides of the shelf, and 20
cm above the top-mounted shelf.
• Make sure that the surface behind the shelf is flat and free of obstacles, so that the openings on the
back of the shelf will not be blocked.
• Make sure that the surface behind the shelf is not made of wood.
• Be careful not to drop the shelf.
Installation Manual 83
2.2.7 Installation of 4-shelf System (Side-by-side Type)