System Initialisation Procedure
1. Slide the System Initialise Switch to the "SYSTEM INITIALIZE" position.
2. Plug the AC power cord into the PBX and an AC outlet, and turn on the PBX. The RUN indicator will flash.
Note
For safety reasons, do not stretch, bend, or pinch the AC power cord.
3. While the RUN indicator is flashing, slide the System Initialise Switch back to the "NORMAL" position.
Depending on the configuration, initialisation takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and stay lit.
All data will be cleared, and the PBX as well as all optional service cards (except for the IP-GW card) will be
initialised to the default values. The DPTs should show the time as 01:00.
The data of the IP-GW card will not be initialised.
304 Installation Manual
2.16.1 Starting the PBX
To Next Page
Loading...
