Panasonic KX-UTG200

ECO Mode
Setting Description Value Range Default
ECO Mode Enabling this mode reduces the
amount of electricity consumed by
the unit.
On, Off Off
Note
• When ECO mode is enabled, the Speed/Duplex setting (Page 52) for LAN Port and PC Port changes
as follows:
– Speed/Duplex: "10M-Full"
– PC port cannot be used.
• When the ECO mode setting is changed, the unit will restart.
• When ECO mode is enabled,
is displayed in the status bar at the top of the screen.
Screen Saver
Setting
Description Value Range Default
Wait Time (0-10min) Period of idle time (in minutes) before
the screen saver is displayed.
0-10 0
Basic Call Features
FWD/DND Settings
If multiple lines are available at your unit, press [ ] or [ ] to select the line to apply the settings to when you
select "FWD/DND Settings" and "Block Anonymous Call".
Setting Sub-Setting Description
Value
Range
Default
FWD/DND Settings Do Not Disturb Enable DND (Do Not Disturb) to
reject all incoming calls.
On, Off Off
Enable FWD All Enable or disable forwarding of
all incoming calls to a specified
destination.
On, Off Off
FWD All Number Specify the number to forward
calls to when "Enable FWD
All" is enabled.
1-32 digits —
Enable FWD Busy Enable or disable forwarding of
incoming calls to a specified
destination when you are on a
call.
On, Off Off
FWD Busy Number Specify the number to forward
calls to when "Enable FWD
Busy" is enabled.
1-32 digits —
Document Version 2014-11 Operating Instructions 47
Customizing the Telephone