Panasonic KX-UTG200

Status Message
Setting Description Value Range Default
Status Message View a list of status messages for the
unit. Press [ ] and [ ] to display the
various messages.
— —
Network Settings
IMPORTANT
We recommend configuring these settings with your administrator or dealer. Network settings can also be
configured through Web user interface programming (Page 58). Contact your administrator or dealer for
further information.
Network
Setting
Sub-Setting Description Value Range Default
IP Address Mode — Specify the IP address mode
to use.
IPv4 only
IPv6 only
Dual stack
Dual
stack
IPv4 Enable DHCP Enable or disable DHCP for
IPv4.
Yes, No Yes
IP Address If DHCP is not enabled, you
must specify the IP address.
xxx.xxx.xxx.xxx —
Subnet Mask If DHCP is not enabled, you
must specify the subnet
mask.
xxx.xxx.xxx.xxx —
Default Gateway If DHCP is not enabled, you
must specify the default
gateway.
xxx.xxx.xxx.xxx —
Auto DNS Enable or disable Auto DNS
for IPv4.
Yes, No Yes
DNS1 If Auto DNS is not enabled,
you can specify the primary
DNS server IP address.
xxx.xxx.xxx.xxx —
DNS2 If Auto DNS is not enabled,
you can specify the
secondary DNS server IP
address. Leave blank if a
secondary DNS server is not
used.
xxx.xxx.xxx.xxx —
IPv6 Enable IPv6
DHCP
Enable or disable DHCP for
IPv6.
Yes, No Yes
Allow Auto
Configuration
Enable or disable auto
configuration for IPv6.
Yes, No Yes
Document Version 2014-11 Operating Instructions 49
Customizing the Telephone