7. Recording Motion Pictures
158
• Operation noise may be recorded during motion picture recording if you operate the zoom or
use buttons or switches, for example.
• If the Extra Optical Zoom are used before pressing the motion picture button, those settings
will be cleared, so the shooting range will change dramatically.
• The zoom speed decreases during the recording of a motion picture.
• Depending on the type of the card, the card access indication may appear for a while after
recording motion pictures. This is not a malfunction.
• When the aspect ratio setting is different in still and motion pictures, the angle of view
changes at the start of motion picture recording.
When [Rec Area] is set to [ ], angle of view during motion picture recording is displayed.
• The [Sensitivity] will be set to [AUTO] (for motion pictures) when recording motion pictures.
(except for Creative Video Mode)
• It will be recorded in the following categories for certain Recording Modes.
Selected Recording Mode
Recording Mode while
recording motion picture
– [Clear in Backlight] (Scene Guide Mode) Portrait Mode
– [Clear Nightscape]/[Artistic Nightscape]/[Handheld
Night Shot]/[Clear Night Portrait] (Scene Guide Mode)
Low Light Mode
Not available in these cases:
• Motion pictures cannot be recorded in the following cases.
– [Glistening Water]/[Glittering Illuminations]/[Soft Image of a Flower] (Scene Guide Mode)
– [Rough Monochrome]/[Silky Monochrome]/[Soft Focus]/[Star Filter]/[Sunshine] (Creative
Control Mode)
– When recording with [Post Focus]
– When using [Time Lapse Shot]
– When using [Stop Motion Animation]
To Next Page
Loading...
Need help?
General
