3. Recording Modes
66
Taking Pictures with Automatically Adjusted
Aperture and Shutter Speed
(Programme AE Mode)
Recording Mode:
The camera automatically sets the shutter speed and the aperture value according to the
brightness of the subject.
You can take pictures with greater freedom by changing various settings in the [Rec]
menu.
1
Set the mode dial to [ ].
2
Press the shutter button halfway and display
the aperture value and shutter speed value
on the screen.
A Aperture value
B Shutter speed
• If the exposure is not adequate when the shutter button is pressed halfway, the aperture
value and shutter speed turn red and blink.
In Programme AE Mode, you can change the preset aperture value and shutter speed
without changing the exposure. This is called Programme Shift.
You can make the background more blurred by decreasing the aperture value or record a
moving subject more dynamically by slowing the shutter speed when taking a picture in
Programme AE Mode.
1 Press the shutter button halfway and display the aperture value and shutter
speed value on the screen.
2 While the values are displayed (about 10 seconds),
perform Programme Shift by rotating the rear dial or
front dial.
A Programme Shift indication
• To cancel Programme Shift, turn off this unit or rotate the
front/rear dial until the Programme Shift indication disappears.
Programme Shift can easily be cancelled by setting a function button to [One Push AE].
(P72)
Programme Shift
Not available in these cases:
• Programme Shift is not available in the following cases:
– When recording 4K photos
– When recording with [Post Focus]
– When the ISO sensitivity is set to [ ]
98
9860
602.8
2.8
2
00
0
r98
r98
6060604.04.04.0
2
00
SSSSSS
FF
0
989898
250 15
4.02.8 5.6 8.0
3060125
To Next Page
Loading...
Need help?
General
