59
2. Getting Started/Basic Operations
Entering Text
1
Press 3/4/2/1 to select text and then press
[MENU/SET] to register.
• Move the cursor to [ ] and then press [MENU/SET] to
switch text between [A] (capitals), [a] (lower case), [1]
(numbers) and [&] (special characters).
• To enter the same character twice, move the cursor by
rotating the rear dial to the right or the zoom lever to the [T] side.
• The following operations can be performed by moving the cursor to the item and
pressing [MENU/SET]:
–[]]: Enter a blank
– [Delete]: Delete a character
–[ ]
¢
: Move the entry position cursor to the left
–[ ]
¢
: Move the entry position cursor to the right
¢It can also be moved with the rear dial or zoom lever.
• A maximum of 30 characters can be entered.
(Maximum of 9 characters when setting names in [Face Recog.])
• A maximum of 15 characters can be entered for [ ], [ ], [ ], [ ] and [ ].
(Maximum of 6 characters when setting names in [Face Recog.])
2
Press 3/4/2/1 to move the cursor to [Set] and then press
[MENU/SET] to end text input.
To Next Page
Loading...
