10. Using the Wi-Fi function
260
Wi-Fi function
∫ Before Use
• Set the date and time settings in advance. (P33)
• To use the Wi-Fi function on this unit, a wireless access point or a destination device equipped
with the wireless LAN function is required.
∫ About the Wi-Fi connection lamp
∫ About the [Wi-Fi] button
In these operating instructions, a function button to which [Wi-Fi] is assigned is referred to
as the [Wi-Fi] button. (By default, [Wi-Fi] is assigned to [Fn8] when the camera is in
Recording Mode, while it is assigned to [Fn4] when the camera is in Playback Mode.)
• For information about the function button, refer to P55.
Steps for pressing [Wi-Fi] (in Recording Mode)
1 Touch [ ].
2 Touch [ ].
When the camera is not connected to Wi-Fi, press [Wi-Fi]. The camera will then be
ready to be connected to the smartphone. You can connect the camera directly to
the smartphone. (P263)
• When the camera is ready to be connected, you can press [DISP.] to connect with the same
settings as used previously. This is a convenient and quick way to establish a connection.
(P294)
Lit blue: When the Wi-Fi function is ON or connected by
Wi-Fi
Blinking blue: When sending picture data
Fn9
Fn8
Fn10
Fn11
SNAP
Fn12
Fn8
To Next Page
Loading...
