Panasonic Lumix DMC-FZ2000

11. Connecting to other equipment
310
1 Press 2/1 to select the picture and then press
[MENU/SET].
2 Press 3 to select [Print start] and then press [MENU/
SET].
1 Press 3.
2 Press 3/4 to select an item and then press [MENU/SET].
3 Press 3 to select [Print start] and then press [MENU/SET].
• Disconnect the USB connection cable after printing.
• Use a battery with sufficient battery power or the AC adaptor (optional). If the remaining
battery power becomes low while the camera and the printer are connected, the status
indicator blinks and the alarm beeps. If this happens during printing, stop printing at once. If
not printing, disconnect the USB connection cable.
• Do not disconnect the USB connection cable while [å] (Cable disconnect prohibit icon) is
displayed.
(May not be displayed depending on the type of printer used.)
• Before inserting or removing a card, turn the camera off, and disconnect the USB connection
cable.
Not available in these cases:
• Motion pictures, 4K burst files, and pictures recorded with [Post Focus] cannot be printed.
Selecting a single picture and printing it
Selecting multiple pictures and printing them
[Multi Select]
Multiple pictures are printed at one time.
•Press 3/4/2/1 to select the pictures and then press [MENU/
SET].
(When [MENU/SET] is pressed again, the setting is cancelled.)
• After the pictures have been selected, press 2 to select [OK], and
then press [MENU/SET].
[Select All] Prints all the stored pictures.
[Print Set (DPOF)] Prints the pictures set in [Print Set] only. (P255)
[Favorite] Prints the pictures set as favourites only. (P255)
0XOWL3ULQW
3ULQW
PictBridgePictBridge