VQT2S30
142
Advanced (Recording pictures)
• It will display dial operation guide to the screen that is possible to
perform Exposure Compensation, Program Shift, aperture setting, or
shutter speed setting when set to [ON].
A Dial operation guide
• Imaging device and image processing is optimized when the camera is purchased. Use this
function when bright spots not in subject get recorded, and it is bothering you.
• Turn the camera off and on after the pixels are corrected.
• Dust reduction function will operate automatically when the camera is turned on, but you can
use this function when you see dust. (P186)
[TOUCH SHUTTER]
Enables/disables the Touch Shutter function.
[OFF]: Touch Shutter icon is not displayed on the screen, and
the Touch Shutter function is disabled.
[ON]: Touch Shutter icon is displayed on the screen, and
[ON]/[OFF] of the Touch Shutter function can be
switched when the icon is touched.
[TOUCH GUIDE]
When playing back the pictures, this allows you to set either to
display or not display the guide screen of the touch panel.
[OFF]/[ON]
[TOUCH SCROLL]
This allows you to set the speed of continuously forwarding or
rewinding pictures using touch operation.
[
H]: High speed
[
L]: Low speed
[DIAL GUIDE]
Sets if the operation switch guide when the mode dial is switched
to , , and is to be displayed or not.
[OFF]/[ON]
[MENU RESUME]
The last operated menu position is saved even if the camera is
turned off.
[OFF]/[ON]
[PIXEL REFRESH]
It will perform optimization of imaging device and image
processing.
[SENSOR CLEANING]
Dust reduction to blow off the debris and dust that have affixed to
the front of the imaging device is performed.
DMC-G2KPP-VQT2S30_eng.book 142 ページ ２０１０年４月１３日 火曜日 午後９時２０分
To Next Page
Loading...
Need help?
General
