77
VQT2S30
Advanced (Recording pictures)
[REC] Mode:
Taking Pictures with the Self-timer
Set the drive mode lever to [ë].
Press the shutter button halfway to focus
and then press it fully to take the picture.
A When self-timer is set to [ ].
• A picture is not taken until the subject is brought into
focus.
Focus and exposure will be set when the
shutter button is pressed halfway.
•
If you want to press the shutter button fully to take a
picture even when the subject is not focused, set [FOCUS PRIORITY] in the [CUSTOM]
menu to [OFF]. (P138)
• The self-timer indicator B blinks and the shutter is activated after
10 seconds (or 2 seconds).
• If you press [MENU/SET] while taking a picture with the self-timer, it
is canceled.
• When [ ] is selected, the self-timer indicator blinks again after the
first and the second pictures are taken and the shutter is activated
2 seconds after it blinks.
∫ Changing the time setting for the self-timer
1 Select [SELF-TIMER] in the [REC] Mode menu. (P32)
2 Press 3/4 to select the mode and then press
[MENU/SET].
•
If you set [ ], after 10 seconds the camera takes 3 pictures at about 2 second intervals.
3 Press [MENU/SET] to close the menu.
•
You can also press the shutter button halfway to close the menu.
Note
•
When using a tripod etc., setting the self-timer to 2 seconds is a convenient way to avoid the
jitter caused by pressing the shutter button.
• We recommend using a tripod when recording with the self-timer.
• Depending on the recording conditions, the recording interval may become more than
2 seconds when [ ] is selected.
• The flash output may not be constant when [ ] is set.
Item Settings
10 seconds
10 seconds/3 pictures
2 seconds
DMC-G2KPP-VQT2S30_eng.book 77 ページ ２０１０年４月１３日 火曜日 午後９時２０分
To Next Page
Loading...
Need help?
General
