VQT2S30
76
Advanced (Recording pictures)
∫ Changing the settings for [STEP] and [SEQUENCE] in Auto Bracket
1 Select [AUTO BRACKET] in the [REC] Mode menu. (P32)
2 Press 3/4 to select [STEP] or [SEQUENCE] and then
press 1.
3 Press 3/4 to select the setting and then press [MENU/SET].
4 Press [MENU/SET] twice to close the menu.
•
You can also press the shutter button halfway to close the menu.
Note
•
When taking pictures using Auto Bracket after setting the Exposure Compensation range, the
pictures taken are based on the selected Exposure Compensation range.
• The exposure may not be compensated with Auto Bracket depending on the brightness of the
subject.
• The Auto Review function is activated regardless of the Auto Review setting. (Will not hold) You
cannot set the Auto Review function in the [SETUP] menu.
• When the flash is activated, you can take only 1 picture.
• Set number of pictures cannot be recorded if the recordable number of pictures is less than set
number of pictures.
• Settings for Multi Film Bracket have priority during the Multi Film Bracket recording
(P93).
• The Auto Bracket will be disabled during recording of the motion pictures.
Item Settings Item Settings
[STEP]
[3•1/3] (3 pictures)
[SEQUENCE]
[0/`/_]
[3•2/3] (3 pictures) [`/0/_]
[5•1/3] (5 pictures)
[5•2/3] (5 pictures)
[7•1/3] (7 pictures)
[7•2/3] (7 pictures)
DMC-G2KPP-VQT2S30_eng.book 76 ページ ２０１０年４月１３日 火曜日 午後９時２０分
To Next Page
Loading...
Need help?
General
