157
VQT2S30
Advanced (Playback)
This mode allows you to automatically display pictures vertically if they were recorded
holding the camera vertically or rotate pictures manually in 90o steps.
Select [ROTATE] on the [PLAYBACK] Mode menu. (P32)
• The [ROTATE] function is disabled when [ROTATE DISP.] is set to [OFF].
Press 2/1 to select the picture and then press
[MENU/SET].
• Motion pictures and protected pictures cannot be rotated.
Press 3/4 to select the direction to rotate the
picture and then press [MENU/SET].
Press [‚] to return to the menu screen.
• Press [MENU/SET] to close the menu.
Select [ROTATE DISP.] on the [PLAYBACK] Mode menu. (P32)
Note
•
[ROTATE DISP.] can only be used with the lens (P18) compatible with the Direction Detection
Function (P41).
• When you play back pictures on a PC, they cannot be displayed in the rotated direction unless
the OS or software is compatible with Exif. Exif is a file format for still pictures which allows
recording information etc. to be added. It was established by “JEITA (Japan Electronics and
Information Technology Industries Association)”.
• It may not be possible to rotate pictures that have been recorded with other equipment.
• The display is not rotated during Multi Playback (P58).
• Pictures recorded with the camera upside down will not be displayed rotated.
N [ROTATE]/M [ROTATE DISP.]
Rotate (The picture is rotated manually)
: The picture rotates clockwise in steps of 90o.
: The picture rotates counter-clockwise in steps of 90o.
Rotate display (The picture is automatically rotated and displayed)
Press 4 to select [ON] and then press
[MENU/SET].
• The pictures are displayed without being rotated when you
select [OFF].
• Refer to P57 for information about how to play back pictures.
Press [MENU/SET] to close the menu.
DMC-G2KPP-VQT2S30_eng.book 157 ページ ２０１０年４月１３日 火曜日 午後９時２０分
To Next Page
Loading...
Need help?
General
