4. Focus and Shutter (Drive Mode) Settings
108
• You can also enlarge the area by rotating the focus ring, moving the focus lever, or
pinching out (P49) the screen or touching the screen twice.
• You can also determine the area to be enlarged by dragging (P49) the screen.
• If you press [DISP.], the area to be enlarged will be reset to the center.
4
Adjust the focus.
A Indicator for ¶ (infinity)
B MF Assist (enlarged screen)
C Peaking
D MF Guide
• The in-focus portions will be highlighted. (Peaking)
(P111)
• You can check whether the point of focus is to the near
side or to the far side. (MF Guide) (P308)
You can perform the following operations:
¢ When using an interchangeable lens with no focus ring, you cannot move the
enlarged area. If you press 4, the screen that lets you set the area to be enlarged will
be displayed.
• When the picture is displayed in windowed mode, you can enlarge/reduce the picture by
approximately 3 to 6
k; when the picture is displayed in full screen, you can enlarge/
reduce the picture by approximately 3 to 10
k.
• If you use the HDMI output during recording, the screen cannot be enlarged in
windowed mode.
Button operation Touch operation Description of operation
3/4/2/1
¢
Dragging Moves the enlarged area
Pinching in/out Enlarges/reduces the screen (by steps of 0.1k)
s Enlarges/reduces the screen (by steps of 1.0k)
Switches the enlarged display (windowed/full
screen)
[DISP.] [Reset]
Resets the area to be enlarged back to the
center.
To Next Page
Loading...
Need help?
General
