191
8.
Recording Motion Pictures
Recording Motion Picture
This can record full high definition motion pictures compatible with the AVCHD format or
motion pictures recorded in MP4, MOV.
The functions available when recording motion pictures differ according to the lens you are
using, and the operational sound of the lens may be recorded.
Refer to P21 for details.
1
Start recording by pressing the motion
picture button.
A Elapsed recording time
B Available recording time
• Recording of motion picture appropriate for each mode is
possible.
• The recording state indicator (red) C will flash while
recording motion pictures.
• If no operation is performed, part of the information on
the screen will gradually become darker after
approximately 10 seconds has passed, and will no longer
be displayed after approximately 1 minute has passed.
Pressing the [DISP.] button or touching the monitor will
make the display reappear. This operation is to prevent
screen burn-in and is not a malfunction.
• Release the motion picture button right after you press it.
2
Stop the recording by pressing the motion picture button again.
• Still picture recording is also possible during the motion picture recording by fully
pressing the shutter button. (P200)
Applicable modes:
About the operation sound that is produced when you stop recording
Since motion picture recording stops only after you press the motion picture button, the
sound of the operation may be noticeable. If the sound bothers you, try the following:
–
Divide the last part of the motion picture using [Video Divide] (P242) in the [Playback]
menu.
The motion picture may not be divided near the very end of it. To avoid this, record
approximately 3 seconds longer.
– Set the camera to Creative Video Mode, and use a shutter remote control (optional) to
record motion pictures. (P353)
To Next Page
Loading...
Need help?
General
