5. Picture Quality and Color Tone Settings
146
The camera automatically removes noise that appears when the shutter speed becomes
slower to take pictures of night scenery etc. so you can take beautiful pictures.
Settings: [ON]/[OFF]
•
[Long shutter noise reduction ongoing] is displayed for the same time as the shutter speed for
signal processing.
• We recommend using a tripod when the shutter speed is slowed to take pictures.
Not available in these cases:
•
In the following cases, [Long Shtr NR] does not work:
– When [Burst Rate] is set to [SH]
– When [Electronic Shutter] is set to [ON]
When the screen periphery darkens as a result of the lens characteristics, you can record
pictures with the brightness of the screen periphery corrected.
Settings: [ON]/[OFF]
•
This feature may be automatically disabled, depending on the recording conditions.
• Noise in the periphery of the picture may stand out with higher ISO sensitivity.
Not available in these cases:
•
Correction is not possible in the following cases:
– Recording still pictures while recording a motion picture [only when set to [ ] (motion
picture priorities)].
– When [Burst Rate] is set to [SH].
• Depending on the lens used, [Shading Comp.] may not operate.
Refer to the website for compatible lenses.
Reducing the long shutter noise ([Long Shtr NR])
Applicable modes:
> [Rec] > [Long Shtr NR]
Correcting the brightness on the screen periphery ([Shading Comp.])
Applicable modes:
> [Rec] > [Shading Comp.]
To Next Page
Loading...
Need help?
General
