10. Using the Wi-Fi/NFC Function
262
∫ Changing the connection method
To change the connection method, press [DISP.], and then select the connection method.
When connecting with [Via Network]:
1 Select [Via Network].
•
Follow the connection procedure described on P293 to connect the camera to a wireless
access point.
2 Turn on the Wi-Fi function.
3 Connect the smartphone/tablet to the wireless access point to which the
camera is connected.
4 Start “Image App”. (P258)
When connecting with [WPS Connection]
¢
in [Direct]:
1 Select [Direct].
•
Follow the connection procedure described on P296 to connect the camera to the
smartphone.
2 Start “Image App”. (P258)
¢ WPS is a function that allows you to easily set up a connection with a wireless LAN device
and make security-related settings. To check whether your smartphone supports the
function, refer to the operating instructions of the smartphone.
∫ Terminating the connection
After use, terminate the connection to the smartphone.
1 Press [Wi-Fi] on the camera. (P256)
2 On the smartphone, close “Image App”.
On the camera
(On your smartphone)
On the camera
(On your smartphone)
If you are using an iOS device
On the screen of “Image App”, press the home button to close the app.
If you are using an Android device
On the screen of “Image App”, press the return button twice to close the app.
To Next Page
Loading...
Need help?
General
