10. Using the Wi-Fi/NFC Function
266
A Wi-Fi connection using NFC function is possible by touching the smartphone to this unit,
and you can easily transfer images displayed on the screen.
An image can be sent on site immediately after taking it, so you can easily send it to the
smartphone
¢
of your family or friend.
¢ Installing the “Image App” is required for use.
1 Play back the picture in the camera.
2 Launch “Image App” on the smartphone.
3 While [ ] is displayed on the connection
screen of the “Image App”, touch the
smartphone to [ ] of the camera.
•
It may take time to complete the connection.
• If a connection attempt by touching fails, restart
the “Image App”, and then display the screen in
step
2 again.
• To transfer more than one image, repeat steps
1 and 3.
(They cannot be transferred as a batch.)
• Depending on the environment you are using, it may take a few minutes to complete the image
transfer.
Transferring images stored in the camera easily
Preparation:
(On the camera)
•
Set [NFC Operation] to [ON]. (P302)
• Set [Touch Sharing] to [ON]. (P303)
(On your smartphone)
•
Check that your smartphone is a compatible
model.
• Turn on the Wi-Fi function.
• Install the “Image App” in advance. (P258)
To Next Page
Loading...
Need help?
General
