365
13. Others
[Memory Card Error]/[This memory card cannot be used]
•
Use a card compatible with this unit. (P34)
[Insert SD card again]/[Try another card]
•
An error has occurred accessing the card.
Insert the card again.
• Insert a different card.
[Read Error/Write Error
Please check the card]
•
It has failed to read or write data.
Remove the card after turning this unit off. Insert the card again, turn this unit on, and try to
read or write the data again.
• The card may be broken.
• Insert a different card.
[Cannot record due to incompatible format (NTSC/PAL) data on this card.]
•
If you continue to use the same card after changing [System Frequency] (P220), motion
pictures may not be recorded. To record with the same card, reset [System Frequency] to the
original setting. To record motion pictures with the current setting, try the following:
– Perform formatting (P58) on this unit after saving necessary data on a PC, etc.
– Insert a different card.
[Motion recording was cancelled due to the limitation of the writing speed of the
card]
•
Depending on the [Rec Format] and [Rec Quality] of a motion picture, the speed class rating
required for the card differs. Use a card that meets the rating. For details, refer to
“About the
motion picture recording and speed class
” on P22.
• If the recording stops even when you are using a card that meets the speed class rating, the
data writing speed is too slow. We recommend making a backup and then format the card
(P58).
Depending on the type of the card, motion picture recording may stop in the middle.
[A folder cannot be created]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
Format the card on this unit after saving necessary data on a PC etc. (P58)
If you execute [No.Reset] in the [Setup] menu after formatting, the folder number is reset to
100. (P67)
To Next Page
Loading...
Need help?
General
