2. Getting Started
DVQX1961 (ENG)
28
3
Insert the battery.
≥Insert the terminal end of the
battery and push until a locking
sound is heard.
0
Check that the lever A is holding the
battery in place.
4
Close the battery door.
≥Close the battery door, and move
the battery door release lever to the
[LOCK] position.
Removing the Battery
1
Set the camera on/off switch to [OFF].
2
Open the battery door.
0
Check that the card access light B is
turned off and then open the battery door.
3
Push the lever A in the direction of the
arrow and then remove the battery.
0 Ensure that no foreign objects are adhering to the inner side (rubber seal) of
the battery door.
0 Remove the battery after use.
(The battery will drain if left inserted in the camera for a long period of time.)
0 The battery becomes warm after use, during charging, and immediately after
charging.
The camera also becomes warm during use. This is not a malfunction.
0 Be careful when removing the battery as the battery will jump out.
DC-S1HGN-DVQX1961_eng.book 28 ページ ２０１９年８月８日 木曜日 午後５時５５分
To Next Page
Loading...
