Panasonic PT-DZ21KU

[PROJECTOR SETUP] menu
ENGLISH - 103
Settings
[COOLING CONDITION]
Change the fan control depending on the direction of
projection.
Set [COOLING CONDITION] according to the
projection direction, but set it to [AUTO] normally.
Using the projector with [COOLING CONDITION] set
incorrectly may shorten the life of the lamp.
1) Press

to select [COOLING
CONDITION].
2) Press the <ENTER> button.

z
The [COOLING CONDITION] screen is displayed.
3) Press

to select a cooling condition.

z
When [AUTO] is selected, the cooling conditions
of [FLOOR SETTING], [CEILING SETTING],
[VERTICAL UP SETTING], and [VERTICAL
DOWN SETTING] are set automatically.
You can check the setting from [COOLING
CONDITION] on the [STATUS] screen.
：
[VERTICAL UP
SETTING]
[FLOOR
SETTING]
[CEILING
SETTING]
[VERTICAL DOWN
SETTING]
Projection direction
4) Press the <ENTER> button.
5) When the conrmation is displayed,
select [OK] or [CANCEL], and press
the <ENTER> button.
Note
z
Cannot be set when using the optional accessory
replacement lamp unit (for portrait mode) (Model
No.: ET-LAD510P (1 pc), ET-LAD510PF (4 pcs))
(xed to [PORTRAIT SETTING]).
[HIGH ALTITUDE MODE]
Set to [ON] to use the projector at 1 400 m (4 593 ft)
to 2 700 m (8 858 ft) elevations.
1) Press

to select [HIGH ALTITUDE
MODE].
2) Press
󱽃󱽄
to switch [HIGH ALTITUDE
MODE].
[OFF] [ON]
[OFF]
When using at a place lower than
1 400 m (4 593 ft) above sea level
[ON]
When using at a high altitude
(1 400 m (4 593 ft) or higher and
lower than 2 700 m (8 858 ft) above
sea level)
3) When the conrmation is displayed,
select [OK] or [CANCEL], and press
the <ENTER> button.
Note
z
The speed of the fan increases and the operation
sound becomes louder when set to [ON].
z
This item cannot be set when using the optional
smoke cut lter. (Setting is xed to [OFF].) Use the
projector at a place lower than 1 400 m (4 593 ft)
above sea level.
[LAMP SELECT]
Select luminous lamps from the four equipped in the
projector body to turn on for a certain use condition or
purpose.
1) Press

to select [LAMP SELECT].
2) Press
󱽃󱽄
to switch [LAMP SELECT].

z
The setting will change as follows each time
you press the button.
[L1] [L2]
[QUAD] (4 lit) [L3]
[TRIPLE] (3 lit) [L4]
[DUAL] (2 lit) [L1/L4]
[SINGLE] (1 lit) [L2/L3]
[L2/L3/L4] [L1/L2/L3]
[L1/L3/L4] [L1/L2/L4]