Start-up display
22 - ENGLISH
Preparation
Start-up display
When the projector is switched on for the rst time after purchase as well as when [ALL USER DATA] (
page 117)
in [INITIALIZE] is executed, the focus adjustment screen is displayed after projection starts, then the [INITIAL
SETTING] screen is displayed. Set them in accordance with circumstances.
In other occasions, you can change the settings by menu operations.
■
Focus adjustment
Adjust the focus to display the menu screen clearly.
You may also need to adjust the zoom and shift.
Refer to “Adjusting the focus, zoom, and shift”
(
page 54) for details.
1) Press
to adjust the focus.
+0
FOCUS POSITION
LENS
FOCUS
ADJUST
2) Press the <MENU> button to proceed
to the initial setting.
■
Initial setting (display language)
Select the language to show on the screen. (
page 84)
After completed the initial setting, you can change the
display language from the [DISPLAY LANGUAGE]
menu.
1) Press
to select the desired
language.
(17(5
,1,7,$/6(77,1*
3OHDVHVHOHFW',63/$</$1*8$*(
6(/(&7
6(7
2) Press the <ENTER> button to proceed
to the initial setting.
■
Initial setting (installation setting 1)
Set [PROJECTION METHOD] depending on the
projection method. Refer to “Projection method”
(
page 30) for details.
Set [HIGH ALTITUDE MODE] to [ON] when using the
projector at elevations of 1 400 m (4 593 ft) or higher
and lower than 2 700 m (8 858 ft) above sea level.
After completed the initial setting, you can change the
settings of each item from the [PROJECTOR SETUP]
menu.
1) Press
to select an item.
2) Press
to switch the setting.
When PROJECTION METHOD is changed, confirm that
COOLING CONDITION is set correctly.
Switch to HIGH ALTITUDE MODE "ON" if over 1400m
(4593Ft).
INITIAL SETTING
SET
CHANGEMENU SELECT
PROJECTION METHOD
HIGH ALTITUDE MODE
FRONT/FLOOR
OFF
ENTER
3) Press the <ENTER> button to proceed
to the initial setting.
To Next Page
Loading...
