[SECURITY] menu
ENGLISH - 127
Settings
9) Press
to switch the item.
z
The setting will change as follows each time
you press the button.
[ENABLE] [DISABLE]
[ENABLE] Enables button operations.
[DISABLE] Disables button operations.
z
The following items are available when [SDI1/2
BUTTON] is selected in [INPUT SELECT
BUTTON] on PT-DZ21KU or PT-DS20KU.
[TOGGLE]
Switches between SDI1 and SDI2
during button operations.
[SDI1] Fixes to SDI1.
[SDI2] Fixes to SDI2.
[DISABLE] Disables button operations.
z
When [INPUT SELECT BUTTON] is selected in
Step 8), press the <MENU> button to return to
the [REMOTE CONTROL] screen.
10)
Press
to select [APPLY], and
press the <ENTER> button.
z
The conrmation screen is displayed.
11)
Press
to select [OK], and press
the <ENTER> button.
Note
z
When a button operation is performed on the
device set to [DISABLE], the [CONTROL DEVICE
PASSWORD] screen is displayed.
Enter the control device password.
z
The [CONTROL DEVICE PASSWORD] screen
will disappear when there is no operation for
approximately ten seconds.
z
It will not be possible to turn off the power (standby
status) if the operations of both of [CONTROL
PANEL] and [REMOTE CONTROL] are set to
[DISABLE].
z
When the setting has completed, the menu screen
will disappear. To operate continuously, press the
<MENU> button to display the main menu.
z
Even when button operation on the remote control
is disabled, the <ID SET> button and the <ID ALL>
button are enabled.
[CONTROL DEVICE
PASSWORD CHANGE]
The control device password can be changed.
1) Press
to select [CONTROL
DEVICE PASSWORD CHANGE].
2) Press the <ENTER> button.
z
The [CONTROL DEVICE PASSWORD
CHANGE] screen is displayed.
3) Press
to select the text, and
press the <ENTER> button to enter the
text.
4) Press
to select [OK], and
press the <ENTER> button.
z
To cancel, select [CANCEL].
Attention
z
The initial password when used for the rst time or
after initializing all the user data is “AAAA”.
z
Change the password periodically that is hard to
guess.
To Next Page
Loading...
