Setting up
30 - ENGLISH
Getting Started
Setting up
Projection method
You can use the projector with any of the following six projection methods. Set [PROJECTION METHOD]
depending on the installation location. Set [COOLING CONDITION] to [AUTO]. Using the projector with [COOLING
CONDITION] set incorrectly may shorten the life of the lamp.
■
Mounting on the ceiling and
projecting forward
■
Setting on a desk/oor and
projecting from rear
(Using the translucent screen)
Menu item
*1
Method
[PROJECTION
METHOD]
[FRONT/CEILING]
[COOLING
CONDITION]
[AUTO]
Menu item
*1
Method
[PROJECTION
METHOD]
[REAR/FLOOR]
[COOLING
CONDITION]
[AUTO]
■
Mounting on the ceiling and
projecting from rear
(Using the translucent screen)
■
Setting on a desk/oor and
projecting forward
Menu item
*1
Method
[PROJECTION
METHOD]
[REAR/CEILING]
[COOLING
CONDITION]
[AUTO]
Menu item
*1
Method
[PROJECTION
METHOD]
[FRONT/FLOOR]
[COOLING
CONDITION]
[AUTO]
■
Portrait setting and projecting
from rear
*2
(Using the translucent screen)
■
Portrait setting and projecting
forward
*2
Menu item
*1
Method
[PROJECTION
METHOD]
[REAR/FLOOR]
[COOLING
CONDITION]
[PORTRAIT SETTING]
*3
Menu item
*1
Method
[PROJECTION
METHOD]
[FRONT/FLOOR]
[COOLING
CONDITION]
[PORTRAIT SETTING]
*3
*1: For menu item details, see the [PROJECTOR SETUP] menu → [PROJECTION METHOD] (
page 102) and [COOLING
CONDITION] (
page 103).
*2: For portrait setting, use the optional accessory replacement lamp unit (for portrait mode) (Model No.: ET-LAD510P (1 pc),
ET-LAD510PF (4 pcs)).
*3: Using the optional accessory replacement lamp unit (for portrait mode) (Model No.: ET-LAD510P (1 pc), ET-LAD510PF (4 pcs))
will set the cooling condition to [PORTRAIT SETTING].
To Next Page
Loading...
