About your projector
24 - ENGLISH
Preparation
About your projector
Remote control
■
Front
(1) Remote control indicator
Flashes if any button in the remote control is pressed.
(2)
Power standby <
> button
Sets the projector to the standby mode when the <MAIN
POWER> switch on the projector is set to <ON>.
(3)
Power on <
> button
Starts projection when the <MAIN POWER> switch on
the projector is set to <ON> when the power is switched
off (standby mode).
(4) Input selection (<RGB1>, <RGB2>, <DVI-D>,
<VIDEO>, <HDMI>, <SDI 1/2>) buttons
Switches the input signal to project. (
page 60)
(5) <MENU> button/<ENTER> button/
buttons
Used to operate the menu screen. (
page 63)
(6) <ON SCREEN> button
Switches on (display)/off (not display) the on-screen
display function. (
page 60)
(7) <TEST> button
Displays the test pattern. (
page 62)
(8) Number (<0> - <9>) buttons
Used when the system uses multiple projectors.
Used to input ID numbers or passwords.
(9) <STATUS> button
Displays the projector information.
(10) <LIGHT> button
Pressing this button lights up the remote control buttons.
The lights will go off when the remote control operation
goes idle for 10 seconds.
Automatically adjusts the image display position while
projecting the image.
[PROGRESS] is displayed on the screen while the image
is adjusted automatically. (
page 61)
(12) <SHUTTER> button
Used to temporarily turn off the image. (
page 60)
Switches the aspect ratio of the image. (
page 62)
(14) Lens (<FOCUS>, <ZOOM>, <SHIFT>) buttons
Adjusts the projection lens. (
pages 52, 54)
(15) <FUNC> button
You can assign a frequently used operation to a shortcut
button. (
page 61)
(16) <DEFAULT> button
Restores the contents of the sub-menu to factory default.
(
page 64)
(17) <ID SET> button
Sets the ID number of the remote control when the
system uses multiple projectors.
(
page 29)
(18) <ID ALL> button
Simultaneously controls all the projectors with one
remote control when the system uses multiple projectors.
(
page 29)
To Next Page
Loading...
