[NETWORK] menu
ENGLISH - 131
Settings
Accessing from the Web browser
1) Start up the Web browser on the computer.
2) Enter the IP address set on the projector into the URL entry eld of the Web browser.
3) Enter the user name and the password.
z
The factory default setting of the user name is user1 (user rights)/admin1 (administrator rights) and the
password is panasonic (lower case).
4) Click OK.
z
The [Projector status] page is displayed.
Note
z
If you use a Web browser to control the projector, set [WEB CONTROL] to [ON] in [NETWORK CONTROL]
(
page 128).
z
Do not perform setting or control simultaneously by starting up multiple Web browsers. Do not set or control the
projector from multiple computers.
z
Change the password rst.(
page 144)
z
The administrator rights allows to use all functions. The user rights allow use of [Projector status] (
page 132),
confirmation of the error information page (
page 133), [Network status] (
page 134), [Basic control] (
page 136),
and [Change password] (
page 144) only.
z
Access will be locked for few minutes when an incorrect password is entered three times consecutively.
To Next Page
Loading...
