[NETWORK] menu
134 - ENGLISH
Settings
Parameter Description
[AROUND LAMP TEMP. SENSOR]
There is a problem with the sensor used to detect exhaust air
temperature. Consult your dealer.
[BATTERY] The battery replacement is required. Consult your dealer.
[LENS MOUNTER] There is a problem in the lens mounter. Consult your dealer.
[BRIGHTNESS SENSOR]
There is a problem with the luminance sensor. If the problem is not
corrected by turning off the power and turning it on again, consult
your dealer.
[ANGLE SENSOR]
There is a problem with the sensor that detects angle. Consult your
dealer.
[FILTER UNIT]
The air lter unit is not attached. Check the connection of the air lter
unit. (
page 150)
[AIR FILTER]
There are too much dust accumulated in the air lter unit.
Turn off the <MAIN POWER> switch to <OFF> (
page 53), and
clean the air lter (
page 148).
[AC POWER]
AC input voltage is weak. Use electric wiring that can sufciently
withstand the power consumption of the projector.
■
[Network status] page
Click [Status] → [Network status].
The current network setting status is displayed.
To Next Page
Loading...
