Panasonic PT-RZ670

Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 103
f When the correction of [KEYSTONE] is large, edges of characters may be lost. (Only for PT-RW630)
[IMAGE ROTATION]
Set whether to rotate the input image when projecting.
1) Press as to select [IMAGE ROTATION].
2) Press qw to select an item.
f The items will switch each time you press the button.
[OFF] Projects the input image without rotating.
[CLOCKWISE] Rotates the input image by 90° clockwise and project it.
[COUNTERCLOCKWISE] Rotates the input image by 90° counterclockwise and project it.
Note
f [IMAGE ROTATION] cannot be set during [P IN P].
f The on-screen display direction does not change even when [IMAGE ROTATION] is set to other than [OFF]. Set the [DISPLAY OPTION]
menu → [ON-SCREEN DISPLAY] → [OSD ROTATION] (x page 100) as necessary.
[BACK COLOR]
Set the display of the projected screen when there is no signal input.
1) Press as to select [BACK COLOR].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[BLUE] Displays the entire projection area in blue.
[BLACK] Displays the entire projection area in black.
[DEFAULT LOGO] Displays the Panasonic logo.
[USER LOGO] Displays the image registered by the user.
Note
f To create/register the [USER LOGO] image, use “Logo Transfer Software” included in the supplied CD-ROM.
[STARTUP LOGO]
Set the logo display when the power is turned on.
1) Press as to select [STARTUP LOGO].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT LOGO] Displays the Panasonic logo.
[USER LOGO] Displays the image registered by the user.
[NONE] Disables the startup logo display.
Note
f When [USER LOGO] is selected, the display of the startup logo will be kept for approximately 15 seconds.
f To create/register the [USER LOGO] image, use “Logo Transfer Software” included in the supplied CD-ROM.
[UNIFORMITY]
Correct the brightness and color unevenness of the entire screen.
Setting by each color
1) Press as to select [UNIFORMITY].
2) Press the <ENTER> button.
f The [UNIFORMITY] screen is displayed.
3) Press as to select [VERTICAL] or [HORIZONTAL].