Chapter 4 Settings — [DISPLAY OPTION] menu
96 - ENGLISH
f [30Hz], [25Hz], or [24Hz] can be selected only when [1920x1080p] is selected for [RESOLUTION].
10) Press the <ENTER> button.
f The conrmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
Note
f The setting details are displayed in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] of [EDID STATUS].
f The resolution and vertical scanning frequency settings may be required on your computer or video device.
f After conguring settings, your computer or video device or the projector may be required to be restarted.
f Output with resolution and vertical scanning frequency that have been set may not be performed depending on your computer or video
device.
[DVI-D IN]
Switch the setting when the external device is connected to the <DVI-D IN> terminal of the projector and the image is not projected correctly.
1) Press as to select [DVI-D IN].
2) Press the <ENTER> button.
f The [DVI-D IN] screen is displayed.
3) Press as to select [EDID].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[EDID3] Recognizes movie-based video signals and still image signals automatically.
[EDID1]
Select this item mainly when an external device that outputs movie-based video signals (such as a
Blu-ray disc player) is connected to the <DVI-D IN> terminal.
[EDID2:PC]
Select this item mainly when an external device that outputs still image-based video signals (such as
a computer) is connected to the <DVI-D IN> terminal.
5) Press as to select [SIGNAL LEVEL].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Automatically sets the signal level.
[0-255:PC]
Select this item when the signal output from the DVI-D terminal of an external device (such as a
computer) is input to the <DVI-D IN> terminal.
[16-235]
Select this item when the signal output from the HDMI terminal of an external device (such as a Blu-
ray disc player) is input to the <DVI-D IN> terminal via a conversion cable or similar cable.
Note
f The optimal setting varies depending on the output setting of the connected external device. Refer to the operating instructions of the
external device regarding the output of the external device.
f The data for Plug and play will change when the setting is changed. Refer to “List of compatible signals” (x page 176) for a resolution that
supports plug and play.
Setting [EDID MODE]
1) Press as to select [DVI-D IN].
2) Press the <ENTER> button.
f The [DVI-D IN] screen is displayed.
3) Press as to select [EDID MODE].
4) Press the <ENTER> button.
f The [DVI-D EDID MODE] screen is displayed.
5) Press qw to switch [EDID MODE].
f The items will switch each time you press the button.
[DEFAULT] Standard setting.
[SCREEN FIT] Changes data of EDID according to the setting of [SCREEN FORMAT].
To Next Page
Loading...
