Panasonic PT-RZ670

Chapter 4 Settings — [PICTURE] menu
ENGLISH - 77
[DYNAMIC CONTRAST]
Light source control and signal compensation are performed automatically according to the image to make the contrast optimum for the image.
1) Press as to select [DYNAMIC CONTRAST].
2) Press qw or the <ENTER> button.
f The [DYNAMIC CONTRAST] individual adjustment screen is displayed.
3) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] No correction.
[1] Corrects light source control and compensates signals to a small extent.
[2] Corrects light source control and compensates signals to a moderate extent.
[3] Corrects light source control and compensates signals to a large extent.
[USER]
Set any desired correction.
Refer to “Adjusting desired correction amount” (x page 77) for details.
Adjusting desired correction amount
1) Press as to select [DYNAMIC CONTRAST].
2) Press qw or the <ENTER> button.
f The [DYNAMIC CONTRAST] individual adjustment screen is displayed.
3) Press qw to select [USER].
4) Press the <ENTER> button.
f The [DYNAMIC CONTRAST] screen is displayed.
5) Press as to select [AUTO CONTRAST], [MANUAL INTENSITY], or [DYNAMIC GAMMA].
6) Press qw to adjust the correction amount.
Item Adjustment
[AUTO CONTRAST]
(Automatic light source control)
[OFF] No correction.
[1] - [255]
Allows you to set in increments of 1. The larger the value, the
stronger the correction.
[MANUAL INTENSITY]
(Manual light source control)
[0] - [255]
Allows you to set in increments of 1. The larger the value, the
stronger the brightness.
[DYNAMIC GAMMA]
(Adjustment of signal
compensation)
[OFF] No correction.
[1] Slightly compensates the signal.
[2] Moderately compensates the signal.
[3] Strongly compensates the signal.
Note
f When [DYNAMIC GAMMA] is set to [3], the contrast will be maximized.
f The brightness control and dynamic contrast operate simultaneously, but the dynamic contrast does not operate while brightness and color
are being measured.
[SYSTEM SELECTOR]
The projector will automatically detect the input signal, but you can set the system method manually when an unstable signal is input. Set the
system method matching the input signal.
1) Press as to select [SYSTEM SELECTOR].
2) Press the <ENTER> button.
3) Press as to select a system format.
f If signals are input via the <SDI IN> terminal connection, press asqw to select the system format. (Only for PT-RZ670)
f Available system formats vary depending on the input signal.