Chapter 2 Getting Started — Setting up
ENGLISH - 43
Adjusting adjustable feet
Install the projector on a at surface so that the front of the projector is parallel to the screen surface and the projected image is rectangular.
If the screen is tilted downward, the projected image can be adjusted to be rectangular by adjusting the front adjustable feet. The adjustable
feet can also be used to adjust the projector to be level when it is tilted in the horizontal direction.
Adjustable feet can be extended by turning them as shown in the gure. Turning them in the opposite direction will return them to the original
position.
Adjustable range
Each adjustable feet: Approx. 30 mm (1-3/16")
Attention
f Be careful not to block the intake/exhaust with your hands or any objects when adjusting the adjustable feet while the light source is on.
(x page 25)
f When installing the projector on the oor using the adjustable feet, be sure that the adjustable foot in the center of the rear is in contact with
the oor in order to stabilize the image position. (x page 19)
To Next Page
Loading...
