Chapter 4 Settings — [NETWORK] menu
ENGLISH - 143
Error information page
When [Error (Detail)] or [Warning (Detail)] is displayed in the self-test display of the [Projector status] screen, click it to display the error/
warning details.
f The projector may go into the standby status to protect the projector depending on the contents of the error.
1
1 Self-test result display
Displays the item check results.
[OK]:
Indicates that operation is normal.
[FAILED]:
Indicates that there is a problem.
[WARNING]:
Indicates that there is a warning.
r [FAILED] items
Item Description
[MAIN CPU BUS] There is a problem with the microcomputer circuitry. Consult your dealer.
[FAN] There is a problem with the fan or the fan drive circuit. Consult your dealer.
[INTAKE AIR TEMPERATURE]
The intake air temperature is high. The projector may be used in an environment where
the temperature is high, such as near a heating appliance.
[OPTICS MODULE TEMPERATURE]
The temperature around the optics module inside the projector is high. The projector
may be used in an environment where the temperature is high, such as near a heating
appliance.
[EXHAUST AIR TEMPERATURE] The exhaust air temperature is high. The air exhaust port may be blocked.
[LD1 TEMPERATURE] The temperature of the light source is high. The projector may be used in an
environment where the temperature is high, such as near a heating appliance.
[LD2 TEMPERATURE]
[LD1 STATUS] The light source has failed to turn on. Consult your dealer.
[LD2 STATUS]
[INTAKE AIR TEMP.SENSOR]
There is a problem with the sensor used to detect intake air temperature. Consult your
dealer.
[OPTICS MODULE TEMP.SENSOR]
There is a problem with the sensor used to detect temperature inside the projector.
Consult your dealer.
[EXHAUST AIR TEMP.SENSOR]
There is a problem with the sensor used to detect exhaust air temperature. Consult your
dealer.
[LD1 TEMP.SENSOR]
There is a problem with the temperature detection sensor of light source 1. Consult your
dealer.
[LD2 TEMP.SENSOR]
There is a problem with the temperature detection sensor of light source 2. Consult your
dealer.
[BATTERY] Battery replacement is required. Consult your dealer.
[COLOR WHEEL]
There is a problem with the color wheel or the color wheel drive circuit. Consult your
dealer.
[PROJECTION LENS] Attach the projection lens.
[LENS MOUNTER] There is a problem in the lens mounter. Consult your dealer.
[BRIGHTNESS SENSOR]
There is a problem with the brightness sensor. If problems persist even after switching
on the power, consult your dealer.
[PHOSPHOR WHEEL1]
There is a problem with the phosphor wheel 1 or phosphor wheel 1 drive circuit. Consult
your dealer.
[PHOSPHOR WHEEL2]
There is a problem with the phosphor wheel 2 or phosphor wheel 2 drive circuit. Consult
your dealer.
To Next Page
Loading...
